Originally Posted by Flywellnz
I have my EPP ready to cut!
How are you doing the control horns? (close up pic would be great)
I use those el cheapo single pin ones from HC. I first cut a slit into the EPP, glue in a piece of CF flat, then poke a hole right next to it, so when the hindge is pushed in, the shoulder rests on the CF....all done with hot melt glue and a Monokote trim iron.
Before I just soaked thin ply with CA and cut them out with sissors, making the wide enough where they are glued to add stiffness to the flying surface.