View Single Post
Old Feb 05, 2008, 02:04 PM
DiveBombDave is offline
Find More Posts by DiveBombDave
Pull out early!
DiveBombDave's Avatar
Lexington, KY
Joined Jan 2005
1,956 Posts
If you are careful, you can use a micro screwdriver to pry up the little plastic tab that holds the red pin in place, and slide the red pin out of the plastic case and heatshrink or tape it back along the other wires. This is less permanent in case you wish to use the BEC in this ESC later in another build.

Even if it's an extension, I hate to "cut" a wire out of it if there's a better way.


Dave
DiveBombDave is offline Find More Posts by DiveBombDave
Reply With Quote