View Single Post
Old Jan 24, 2008, 03:21 AM
chewytm is offline
Find More Posts by chewytm
Registered User
Ipoh, Perak Malaysia
Joined Jul 2006
4,024 Posts
Hi, mine had a sticker that says 900gm thrust, but there was no sign of prop-rub. When I ran it up on a 25C 2250 3S, the impeller did tub on the shroud. So, did they actually test those fans?

BTW, I am going to use an HXT 80A ESC instead of the EMAX 40A. There wasn't much leeway with the 40A as the wattmeter showed an amp draw of 39A+ at 12.3V. I think the 80A would be much safer.

I have not bothered with balancing the rotor as I don't have a sensitive balancer. Just let it balance itself out. Not a lot of vibration, though.

Will install the linkages tonite in readiness for the weekend maiden. Will just use some colored tapes for orientation and wait to paint it later.

chewy
chewytm is offline Find More Posts by chewytm
Reply With Quote