View Single Post
Old Dec 31, 2007, 08:18 AM
Tony65x55 is offline
Find More Posts by Tony65x55
I'm not flying backwards!
Tony65x55's Avatar
Oshawa, Canada
Joined Sep 2004
3,753 Posts
Quote:
Originally Posted by dlabrie
Now that I have my 33 and 42"BB going I want to try the APBB. I have always had trouble printing out the plans for planes. Here is my current problem.

I set the printer scale on ‘none’ and print. I just cut the wing parts from the Blu_Baby_AP1_60_inch_KFm3 file. I then printed the plans for from the Blu_Baby_AP_Parts_52_inch file. If I line up the print in Tony’s name that bisects 2 pages of the fuse, the tile marks don’t line up. Then if I try to superimpose the monoblock pattern over the fuse, the fuse and mono block don’t match.

Can anyone give me some advice?

Also, I read that there was an issue with the wing incidence. Do I need to accommodate for that?


Thanks,
David
David you probably have the "fit to page" checkbox clicked on your Adobe Acrobat program. Check that first.

There is an incidence issue on the BBAP1/KFm3 combo. Here is a PDF template for the fuse and monobloc for the KFm3 Wing.

Tony
Tony65x55 is offline Find More Posts by Tony65x55
Reply With Quote