View Single Post
Old Nov 18, 2007, 03:24 PM
mode1 is offline
Find More Posts by mode1
Registered User
mode1's Avatar
Southwest Missouri
Joined Oct 2002
1,354 Posts
On my Mini Pulse I used two 6 inch servo extensions for the rudder and elevator servos mounted in the back area of the fuse.

I Omitted the 2 wing extensions by cutting a small size hole in the wing covering on the bottom where the servo & Y wires would meet. Grabbed the factory installed 'pull' string. Cut in half. Tied one side to the Y and pulled end of Y through the hole in wing covering.

Tied the other half to the servo in wing wire. Pulled through the hole. Plugged servo wire and Y harness together, secured with string so they cannot get loose, stuffed back into wing. Put sticker over holes in coverings.

Sounds complicated but only takes a few minutes.

I did not care for the tinted canopy with no pilot so I spray painted the inside with silver after lightly scuffing with fine scuff pad and masking outside.

E-flight 480 motor, APC 11/8 prop, Electron rec, H-55 servos, C.C. 35 controller, T.P.Prolite 2100 3 cell batteries. Left the wheel pants off.

Flying buddy has the same equipment in a M.U.S. Similar performance as my M.P.XT.
mode1 is offline Find More Posts by mode1
Reply With Quote