Thread: Build Log MDC F-14 plans and pics
View Single Post
Old Nov 08, 2007, 11:25 PM
savall21 is offline
Find More Posts by savall21
Go Sabres!
savall21's Avatar
Laurel, MD
Joined Aug 2004
882 Posts
Quote:
Originally Posted by Maybz
I glued everything with foam-safe CA. The wing pivots are Depron discs that are glued in place. I covered the wing roots and pivot holes with Scotch tape which acts as a bushing surface for the pivot. The sweep control rods are 1/16 steel wire with Z-bends to allow for alignment. The Elevon control rods are 3/32 carbon rods with nylon clevises glued on both ends. Flies great (doesn't everyone say that about their own designs?) CG is right at the Carbon center section stiffener. There is room for almost any size battery and CG is easy to adjust. Note the air inlet at the nose. All materials were purchased from RCfoam.com
Wow! Thank you very much for a great design!
savall21 is offline Find More Posts by savall21
RCG Plus Member
Latest blog entry: Laurel Skate Park
Reply With Quote