View Single Post
Old Nov 03, 2007, 09:43 AM
Arthur P. is offline
Find More Posts by Arthur P.
Registered User
Hoofddorp, Netherlands
Joined Sep 2004
3,917 Posts
Once the varnish is dry you can solder some very thin wire over the two resisotor ends to create the jumper bridge, and then very carefully onto the ADC1 pin of the processor. Carefuly insect these connections for unwanted solder bridges to neighbouurng resistors or pins. If necessory bring out the desoldering wick, such up the excess and redo.
Also redo the measurement of resistance between the solder bridge / ADC1 pin and the SDA pin. There should be no connectino.
Arthur P. is offline Find More Posts by Arthur P.
Reply With Quote