View Single Post
Old Sep 25, 2007, 03:30 PM
Griff1 is offline
Find More Posts by Griff1
Registered User
Griff1's Avatar
Wolverhampton,United Kingdom
Joined Aug 2007
116 Posts
Quote:
Originally Posted by d3nys
I tried today to solder the cable but without the resistors. It works but the signal is jumping. Tomorrow I will go to buy the resistors. Where do I put them? On the signal cable I suppose. And yes. The switches to disable ccpm in the esky transmitter works and I have done an unstable test flight in FMS.
Take a look here = http://www.darkhorserc.com/other/esky-simcable.htm

There's a wiring diagram a little ways down the page that will show you where you put the resistors.

With this method you don't need to unmix the ccpm,make sure you tick the esky 6 channel ccpm filter as shown in this pic and then calibrate your controls.

EDIT: Take your tx crystal out too and your battery's will last longer.
Griff1 is offline Find More Posts by Griff1
Reply With Quote