Originally Posted by Griff1
I don't know why people spend their money on these cables when all you need is a 4 pin s-video plug (to plug into the esky tx) a 3.5 mm microphone jack (to plug into your mic input on your pc) a length of 2 core cable (such as speaker cable) a 10K and 1K resistor and SmartPropoplus.
The whole process of making the cable and setting up SmartPropoplus took me less than 10 minutes and i was flying my HB CP2 in Fms,the same setup also works for clearview.
I tried today to solder the cable but without the resistors. It works but the signal is jumping. Tomorrow I will go to buy the resistors. Where do I put them? On the signal cable I suppose. And yes. The switches to disable ccpm in the esky transmitter works and I have done an unstable test flight in FMS.