Originally Posted by Eberwein
One of the tricks I use on long label stock is to make it into a "crack and peel". Pull the trim back a bit and trim the backing. Repeat every cuple inches. Then, when you go to apply it to the model, hold it in place with a couple pieces of LOW tack tape. Remove the front piece of backing, stick it down, remove the next piece of backing, and repeat, until you get the whole thing done.
Well, that should work. Why didn't I think of that
Guess I'll give it a shot that way when I'm ready for the graphics (fairly soon, I hope
PS: Why don't you make a deal w/ Callie or somebody to get a good decal set (minus any copyrighted stuff) for your J3 kits. You could raise the price a bit with no problem, I think.