View Single Post
Old Aug 23, 2007, 02:53 PM
tdearth is offline
Find More Posts by tdearth
Registered User
USA, IN, Nineveh
Joined Apr 2002
2,404 Posts
I ran into one other problem.
I noticed that my wing did not seem to lock down tightly and I found that the
hold down screw was not long inough to extend into it's hardpoint enough.

I went ahead and popped off the little foam wing support because I was going to glue on a taller hardwood block for the screw to meet.
What I found was that there was a 3mm steel blind nut in there, but the hold down screw is a wood screw. I am going to have to find a 3mm machine screw long enough to reach the blind nut. Or just replace the entire wing mount set up with something else.

Did everyone else have a wood screw for the hold down screw?

Tim
tdearth is offline Find More Posts by tdearth
Reply With Quote