View Single Post
Old Jun 27, 2007, 12:53 PM
mikeperik is offline
Find More Posts by mikeperik
Registered User
Joined Mar 2005
199 Posts
I don't use SolidWorks but I use Alibre Xpress and I think the issue is the same. On each former sketch you need to try to get the nodes or control points on the former's sketch to be in approximately the same position. So go to each former and add control nodes at positions like 0, 45, 90, 135, etc degrees then the lofting will use those control nodes for the loft and hopefully you won't have a distorted fuse. Or something like that, I'm by far no expert, I'm learning as well.
mikeperik is offline Find More Posts by mikeperik
Reply With Quote