View Single Post
Old Jun 24, 2007, 02:57 PM
bubbafusion is offline
Find More Posts by bubbafusion
Registered User
bubbafusion's Avatar
Oak Ridge, TN
Joined Jun 2002
391 Posts
Nigel,

I'd be interested in a build thread. I printed the plans this morning and started cutting out some templates. One thing I'm confused about is the fuse cores. The plan says to make two stacks of two 6 mm pieces and one 3 mm piece and then glue the two stacks together. On the other hand, the plan says to make six 6 mm pieces and the rectangular pieces that hold the upper and lower parts together are wide enough for six 6 mm (36 mm) plus two 3 mm (6 mm, for a total of 42 mm). So, I assume the stacks should be three 6 mm pieces each, not just two?
bubbafusion is offline Find More Posts by bubbafusion
Reply With Quote