View Single Post
Old Jun 23, 2007, 05:13 AM
irish_lord99 is offline
Find More Posts by irish_lord99
Balsa for me, thanks.
irish_lord99's Avatar
Yalova, Turkey
Joined May 2007
835 Posts
I'm not really trained in solidworks, but I have been using it for a while and the only thing I have to say about lofts is this:
When selecting each of the profiles for the loft, it helps to click on the same point (or as close as possible) on each profile. For instance, if you want to connect a set of four squares, then clicking on the lower left hand corner of each square will give you a square shaped loft, but if you click on alternate corners you'll get a mess.

Hope that helps.
irish_lord99 is offline Find More Posts by irish_lord99
Reply With Quote