View Single Post
Old Jun 20, 2007, 02:39 PM
pinolefm1 is offline
Find More Posts by pinolefm1
Permanently Banned
pinolefm1's Avatar
Joined Aug 2005
1,292 Posts
this might help ?? http://cmil.west.cmu.edu/cs/blogs/co...05/13/416.aspx

I'm certainly no expert (still struggling with lofting a .dat wing file ) but I've been looking into airframe design in solidworks myself recently and I think what was said before about image planes applies to solidworks as well....."insert" an image on a new plane in sketch mode...
google "airplane solidworks" and you'll find some discussions on how to loft or bridge airplane parts and pieces like the example above
also the included tutorials are realy pretty good

hth

steve
pinolefm1 is offline Find More Posts by pinolefm1
Reply With Quote