View Single Post
Old Jun 11, 2007, 06:29 AM
Norman2 is offline
Find More Posts by Norman2
Norman2
Norman2's Avatar
Connestee Falls, Brevard, North Carolina
Joined Mar 2006
392 Posts
ETNZ Buildidng tips

Will post some close up photos today. I used Cap Maquette fittins for the
chain plates and stay tensioners for side stays and back stay. For rigging
used 90 lb spectra nylon covered line. I did not use a forestay as I think
it is not needed. Passed a 90 lb spectra nylon covered wire through the
front pocket of the jib and she sails fine like that. That takes the place of
a forestay. Again will post photos today. Regards
Norman2 is offline Find More Posts by Norman2
Reply With Quote