Thread: Build Log Flair Puppeteer Build
View Single Post
Old Jun 10, 2007, 09:04 PM
erich is offline
Find More Posts by erich
Registered User
erich's Avatar
Holden , Massachusettes
Joined Feb 2004
2,597 Posts
Engine

Have installed engine and hooked up most of the controls and things.

Photo 1: The red lead is the remote plug line (goes from remote plug to engine plug..duh). White braided line is plug ground, goes to one of the engine block bolts (NOT the mounting screws). Fuel line loop is fill line, loop is for slack needed when filling tank. You can see tank and the carb fuel line just to left of needle valve adjust (long black extension).

Photo 2: Remote plug in upper left corner, should be easy to access, when starting up. You can see here where ground lead is attached to engine. Air pressure line goes to tap on exhaust. Just below this is the throttle connection. Was a pretty tight fit. Would have been a little easier if carb had been in front of engine, oh well, it's in there now.

erich
erich is offline Find More Posts by erich
Reply With Quote