View Single Post
Old Jun 05, 2007, 08:59 PM
Cockar is offline
Find More Posts by Cockar
Registered User
Joined Feb 2007
43 Posts
Hi Guys, next problem, hope someone can help.

Kontronik 480 & Jazz 40-6-18

I finally got time to install the motor into the Siren, but upon connecting up the battery to give the motor a test run, all I got was 3 sounds in an ascending order and the esc constantly blinking. I thought it might have been an error in the transmitter programming so I reversed the throttle stick which didnt seem to do anything. So I removed the motor and esc from the glider to see if there was a problem with the wiring but all is ok. Now when I hook everything up (bat, esc, engine) there is nothing. Any thoughts before I ring Kontronik ?

Also I tried using the jumper both on the esc and w/out but still nothing.

2nd question, once I get the motor running does anyone bother to program the esc to the glider mode ? What is the advantage in doing this ?

Regards and Frustrated
Matt
Cockar is offline Find More Posts by Cockar
Last edited by Cockar; Jun 05, 2007 at 09:13 PM.
Reply With Quote