: Build Log
View Single Post
Jun 04, 2007
, 05:35 AM
I failed linkage geometry
Joined Jun 2002
Getting a bit horny (and corny)
Righty-o then. While the epoxy is curing here's another update.......
Rudder horn time. Refer previous post regarding supplied horn/geometry issues.
View all Images in thread
Here is the stock horn cut down to fit
You can just see the line I scored with an Exacto knife to mark where it protrudes from the rudder
Drill a couple of holes to gives the epoxy more area to stick to and lock it in position
A bit of 5 minute in the slot, fill the holes in the horn and smear the rest and bung it in.
Clean up the spew-out using these (IPA wipes)