Thread: Discussion Micro SSX Build
View Single Post
Old May 29, 2007, 01:08 PM
jkarpy is offline
Find More Posts by jkarpy
jkarpy's Avatar
USA, FL, Orlando
Joined Aug 2006
2,027 Posts

Balancing requires that the wing not be glued directly to the fuselage. You must be able to move the wing forward or aft on the fuselage for balancing. Install all gear, push rods and the battery before balancing. The balance point is 1/8th inch behind the main spar.

After the model is balanced, check to be sure the tail section is aligned with the wing and then glue the wing mounts to the fuselage using medium CA.
jkarpy is offline Find More Posts by jkarpy
RCG Plus Member
Last edited by jkarpy; May 29, 2007 at 01:57 PM.
Reply With Quote