Thread: Discussion Solidworks wing modeling
View Single Post
Old May 13, 2007, 07:38 PM
ShaverR6 is offline
Find More Posts by ShaverR6
4th Generation
ShaverR6's Avatar
Canada, SK, Division No. 7
Joined Sep 2004
326 Posts
Ok, what about using the loft tool? I would use the leading and trailing edges as guide curves. These would have to be two different sketches. Then use your root airfoil as your profile. You don't need to use lots of airfoil profiles. Just use a root, then perhaps the profile located near the wing tip.
This probably didn't nail what you were looking for but its a start. Let me know if I can be of more help.
Here is a rough example of what I mentioned.
ShaverR6 is offline Find More Posts by ShaverR6
Reply With Quote