View Single Post
Old May 09, 2007, 01:54 AM
bradb is offline
Find More Posts by bradb
what goes up crash's
bradb's Avatar
Mccrory, Arkansas
Joined Jun 2006
92 Posts
Question
problems with trex 450 after crash

Last week I tried to do a loop with my throttle up switch in normal mode (did not mean to) and it dropped about 60 foot out of the air on to its side. I replaced every thing on it that was broke but the first time I took it out normal mode was fine, idle up 1 was fine, but idle up 2 was not changeing anything its like it was still in idle up 1. I straped the heli down and ran the motor up. I went into idle up 1 changed the throttle curve from 100 70 100 to 100 90 100 and there was no change. it was like the motor would not go over 70% throttle. Also when I fliped the throttle hold switch it would idle down but the rotors was still spinning slightly. I went into the house and reprogramed the esc and now it seems fine but I dont want to fly it untill I get some feedback on this. Can the esc lose its programing in a crash? do you think it just lost the full throttle position? or can it be something other than the esc? I have the align 35a esc
bradb is offline Find More Posts by bradb
Last edited by bradb; May 11, 2007 at 04:53 AM.
Reply With Quote