View Single Post
Old Jan 07, 2003, 07:26 PM
Stuntman is offline
Find More Posts by Stuntman
Upside down Miss Jane....
Stuntman's Avatar
Georgetown, Newcastle, Australia
Joined Aug 2002
2,153 Posts
The norvel is nice, i've seen them run hard in 1/2A pylon and the control line speed guys use them in there little speed models. I definetley go for the norvel over the cox. Both are noisy but I think the cox is noisier and messier.

Alternatively have a look at the thunder tiger GP07. They are great little motors and are just like a minatures of their bigger brothers, with full exhaust air bleed throttle and take "standard" short reach glow plugs, ie an OS8. (the cox and norvel have their own type of glow plug which may not be as easily accesible if you burn one out). My one seems to run fairly clean. And they have a cool purple anodized head if that tickles your fancy.

With the GP07 you'll get 20minutes run time with a 2ounce tank pretty much flat out.

The norvel will take some running in. I ended up with a sore arm after flicking, and flicking and flicking and flicking, ...... before it would fire. The GP07 on the other hand started up much easier straight out of the box.

The norvel 0.061 is a bit smaller than the GP07. The GP07 will let you beam or backplate mount. The norvel is a beam mount.

If your a newbie to motors the GP07 would be a better choice in my opinion.

Hope this helps
Shawn
Stuntman is offline Find More Posts by Stuntman
Reply With Quote