View Single Post
Old Jan 28, 2007, 03:24 PM
Controlled Fall is offline
Find More Posts by Controlled Fall
Registered User
Controlled Fall's Avatar
Chantilly, VA
Joined Dec 2006
213 Posts
Hooray, onto the second page! Wings!

Here's the step that intimidates me the most. However, the high quality "laser cut" made it easier than expected as I didn't even need a knife to remove the parts. I wasn't sure what "Flow a bit of thin CA..." meant, but once again, it figured itself out as I actually started to do it.

Pre-assembly was a good idea as it helped me visually ensure that I did not make the "...two wings of one side, i.e., two right wings. This is a bad thing!" mistake.

I only finished one wing that night as I ran into "technical difficulties" which I will describe below...
Controlled Fall is offline Find More Posts by Controlled Fall
Reply With Quote