View Single Post
Old Dec 30, 2002, 07:10 AM
jdowdle is offline
Find More Posts by jdowdle
Registered User
United States, NC, Franklin
Joined Dec 2002
428 Posts
Re: Cutting carbon rods

Quote:
Originally posted by Bandikoi
I use the cutters from these folks and they work very well with clean cuts.
Of course, it only works on smaller stuff.
Click on the link and then select carbon cutter.
Chuck

http://www.airdyn.com/index.htm

Hi

do you know if any of these tubes at this site will replace the tail boom?

thanks, Jim (thehornetsmasher)
jdowdle is offline Find More Posts by jdowdle
Reply With Quote