Thread: Build Log Yardbird!!!!!
View Single Post
Old Jan 07, 2007, 11:04 PM
schrederman is offline
Find More Posts by schrederman
Hot Dawg Glider Pilot
schrederman's Avatar
United States, TX, Weatherford
Joined Nov 2002
8,010 Posts
More on the stabs

On the original drawing, there were no notes on the stab and rudder drawings. The stab diagonals were intended to be optional 1/16 X 1/8 balsa and the leading edge was to be sheeted top and bottom with 1/20 sheet. When the next set of drawings is done, those tails will still be there with the ribs and plenty of notes. I have sent the drawings to both LaserArts and Isthmus Models. Brian may include these ribs in the short kits... but that's his business. It sure beats cutting them out.

If it wasn't so late, I'd go frame up a couple of stabs... gotta work tomorrow, though...

Jack
schrederman is offline Find More Posts by schrederman
Reply With Quote