View Single Post
Old Jan 06, 2007, 06:13 PM
Diggs is offline
Find More Posts by Diggs
Not your average DiggsyBear
Diggs's Avatar
Raleigh, NC
Joined Dec 2006
8,859 Posts
Quote:
Originally Posted by rgoodwin
When my shaft came loose, I reseated the swashplate improperly as well. In fact I still haven't quite gotten it back in perfect (too much forward motion currently so I must have some forward tilt). It seems to me you just have to move the lower blade holders up and down (w/ the plate attached) until you can eyeball it to be level.

If someone has a better idea, PLEASE let me know I'm sittting at full backwards trim and still have to pull back a little to prevent forward drift.

I removed everything from the shaft today due to TB effect problems. Discovered the outer shaft has a hole in it for the top screw of the lower blade holder. Once I lined it up and mounted the screws, life got much better for me. This will prevent improper spacing between the blades, and will get the distance for the swashplate correct also.

Hope that helps.

Diggs
Diggs is offline Find More Posts by Diggs
Reply With Quote