View Single Post
Old Jan 06, 2007, 12:36 PM
Rhathid is offline
Find More Posts by Rhathid
Gotta make the doughnuts
Toledo Express, Ohio, United States
Joined Oct 2004
631 Posts
Not sure if this would work or not, but I've done this with circuit boards. Using a laser printer I've printed something and then used an iron to transfer the ink powder from the plastic (have to use transparencies) to the board. I wonder if you could try doing that, but you'd have to test it first and make sure it doesn't shrink the monocote.

Also, you'll want to get into the printer setup on your computer and turn off the auto-features and manually increase the tone/darkness to it's maximum.

At least it's an idea, whether it works or not is in the air.
Rhathid is offline Find More Posts by Rhathid
Reply With Quote