View Single Post
Old Dec 27, 2006, 02:28 PM
nkinney is offline
Find More Posts by nkinney
Trader Rating: 3
Registered User
Colorado Springs
Joined Jun 2002
163 Posts
Trader Rating: 3
I don't have pics of the mod. I have placed The TX board back into the DX6 case and donít want take it apart again. It looks just like a DX6 with 3 wires coming off the back of the white factory connector. The leads were not long enough to connect to the Optic6 so I added a servo lead wire to the back of the PCB. Adding the 3 wire lead is very simple just tin the wires and attach them to the pads. The TX board fits inside the optic6 case. If you round out the top hole in the back of the Optic6 plug in module well you can get to the bind button.

-Neil
nkinney is offline Find More Posts by nkinney