View Single Post
Old Dec 25, 2006, 04:02 PM
freecheeseman is offline
Find More Posts by freecheeseman
Registered User
Joined Nov 2006
32 Posts
I went to go move out the rods on the servos to get a bit more forward speed and I was wondering if someone could explain it a bit more in detail. Should I have to take off the arm on the servo? How do I make sure it's in the right position again once i'm done? Does everyone else have 5 holes, cuz i thought I read that it was only 3? Don't want to mess anything up to bad...

thanks
freecheeseman is offline Find More Posts by freecheeseman
Reply With Quote