View Single Post
Old Dec 07, 2006, 12:04 AM
LcJ is offline
Find More Posts by LcJ
Forever TMWT Pilot #11
LcJ's Avatar
United States, LA, Monroe
Joined Mar 2003
6,197 Posts
Not to insult your intelligence, but did you let the transmitter light go solid red before you plugged the heli battery in? Then did you let it remain still after plugging in, especially till the green light come on flashes several times and then turn solid green? Those steps are important.

If after that you still have problems, I would remove the hood (front cover) and look for any possible binding in the servo arm. If all appears good, then I would check the little dip switches at the lower front left of the tx under the cover where the red light is and be sure they match what the manual says.

Also, the binding should have been done prior to packaging so you might want to be sure those steps were done to a "T".

I think any problems will be solved by Horizon.

Good Luck and sorry you had problems.

LcJ is offline Find More Posts by LcJ
RCG Plus Member
Latest blog entry: RC Logger's Eye One Xtreme Quad
Reply With Quote