: Build Log
"Little Go Bipe" - 5-6 oz foam biplane; new design, free plans!
View Single Post
Dec 06, 2006
, 06:01 PM
Somewhere south of Chicago, IL
Joined Jan 2006
Single sheets - full plan
PDF files that have sufficient info to use to trace the outline for all necessary foam parts for this plane. Wings are only 1/2 of total wing; simply flip the cut-out design over to trace the other half.
These should make it easier to print all parts of the plane.
EDIT: A tiled version which prints all these parts is now in post #1.
View all Files in thread
Little Go Bipe Upper Wing half.pdf
One half of upper wing on 11x8.5 sheet (use upside down to trace other half.
Little Go Bipe Lower Wing half.pdf
One half of lower wing on 11x8.5 sheet (use upside down to trace other half).
Little Go Bipe Model Horiz & Wing stabs.pdf
11x8.5 sheet with horizontal stabilizer and wing stabilizer outlines.
Little Go Bipe supports-tail.pdf
11x8.5 sheet with wing supports, wing stabilizer supports and vertical stabilizer outlines.
Last edited by magic612; Jun 07, 2007 at