View Single Post
Old Dec 05, 2006, 08:49 PM
magic612 is offline
Find More Posts by magic612
Bernoulli+Newton=Lift
magic612's Avatar
Somewhere south of Chicago, IL
Joined Jan 2006
1,952 Posts
Remaining radio equipment, pushrod guides

Completed wing stabilizer assembly, and radio gear (ESC not pictured). I used .032" piano wire for the pushrods, but the distance between the servos and the tail assembly is far enough, I decided to add some pushrod supports to avoid pushrod "flex" when the servo was pushing the rods instead of pulling them.

The pushrod support is simply a piece of balsa wood CA'd to the fuselage, and some pushrod tubes epoxied to it.
magic612 is offline Find More Posts by magic612
Reply With Quote