View Single Post
Old Nov 27, 2006, 11:11 PM
Joe Yap is offline
Find More Posts by Joe Yap
Registered User
Singapore
Joined Nov 2001
802 Posts
At this point, I will need to get the fins ready as I need them to carve the fuselage to fin joints to the correct contour. I do not have vacuum bagging facility but I cheated on this one. I laid glasscloths with epoxy resin over a sheet of waxed PVC, peeled them off when the resin has cured and epoxy them over the fin surfaces. The result is very similar to the vacuum bagged ones but I have to touch up on the LE and the TE.
Joe Yap is offline Find More Posts by Joe Yap
Reply With Quote