View Single Post
Old Dec 11, 2002, 12:27 PM
etbadger is offline
Find More Posts by etbadger
Registered User
UT, USA
Joined Mar 2001
63 Posts
My method of choice now is to print onto the paper side of freezer paper (not wax paper, its paper with one side coated in some plastic) and then iron it onto the wood (plastic side down). Then cut out the part and peel off the freezer paper (comes off easily.

The stuff is cheap, irons on nicely (med-high heat), and comes off cleanly even on very light balsa.

You may need to trim the paper a bit to fit your printer as all I have found comes in about 24" wide rolls.

-eb
etbadger is offline Find More Posts by etbadger
Reply With Quote