View Single Post
Old Dec 05, 2002, 06:53 PM
Rogerdoger is offline
Find More Posts by Rogerdoger
Registered User
Rogerdoger's Avatar
United States, CA, Clovis
Joined Apr 2002
3,878 Posts
Good Tips and Information!

DEPENDS,

Well stated! I used some of your information to get the first unit assembled. Thanks for the tips.

I did use the largest pin to break the gear loose from the shaft. After that it just came of easily.

I pushed the small pinion gear onto the shaft. I was worried that it didn't seat on as far as the previous gear, but it was on as far as it wanted to go. I began to assemble the various parts of the GB and found that things just slipped together.

I connected a battery to the motor and away it spun.

After a while the two black pieces came apart, so I used black electrical tape to keep it together. The kit has blue tape supplied for this purpose.
Rogerdoger is offline Find More Posts by Rogerdoger
Reply With Quote