Thread: Discussion Skybench OLY II
View Single Post
Old Oct 10, 2006, 06:53 AM
burgermike is offline
Find More Posts by burgermike
Registered User
Lindale TX
Joined May 2006
64 Posts
Laid out the fuse parts last night and did a dry run. Discovered a minor flaw. There are two bottom fuse pieces-ply front and balsa rear-each has laser cut slots for the formers. The slot in the balsa piece was about 1/2" too far aft. Not a big deal to fix, but could have been interesting had the former been glued in first. The pieces are beautifully made though. I am using a build thread I found on rcuniverse as a guide as well.
burgermike is offline Find More Posts by burgermike
Reply With Quote