View Single Post
Old Nov 26, 2002, 10:15 AM
azflyer is offline
Find More Posts by azflyer
Registered User
azflyer's Avatar
Chandler, Arizona
Joined Jan 2002
226 Posts
Here is an easy method I use all the time.

Photocopy or laser print your parts on regular sheets of paper. Then cut out the parts leaving at least 1/2" white space around the parts. Tape the parts onto balsa around the edges print side down using painters tape. Put some acetone on the back side of the paper with a small brush. Work in small areas at a time and use pleanty it dries fast. Use a wood or rubber roller on the wet paper to transfer the toner ink from the paper to the balsa. You may have to apply more acetone and roll again. Remove the paper and behold, a perfectly transfered part on the balsa.
azflyer is offline Find More Posts by azflyer
Reply With Quote