View Single Post
Old Nov 18, 2002, 08:50 AM
devmonkey is offline
Find More Posts by devmonkey
Registered User
United Kingdom, England, Surrey
Joined Aug 2002
837 Posts
That looks great, i'm going to build one of these.

How do you keep the windings from touching the rotor, or are they completely solid after you have CA'd them together? If so how do you get the kitchen wrap out after building the windings?

I'm interested to know how your sensorless controller senses, since I can't see when the coil would not be energised during a single rotation, and being single phase you do not have a spare phase for feedback.

Stu:
Where did you see that magnet? i'd like order some of them.

This is very exciting for a lightweight ultra high kv edf motor. And the controller is very simple and cheap.

btw, do any of you guys know how to build a switched reluctance motor. It is supposed to be fairly simple, but i've found no diy pages on the subject.

Cheers

Joe
devmonkey is offline Find More Posts by devmonkey
Reply With Quote