View Single Post
Old Aug 17, 2006, 01:43 PM
saabguyspg is offline
Find More Posts by saabguyspg
Registered User
saabguyspg's Avatar
Calgary Canada
Joined Jun 2006
5,159 Posts
As an addition.... all the lube points can be accessed by taking the clear plastic protector thingy off and lubing through there... so .. no need to take anything apart.

Easy way to do this is... put some lube (3 in one not wd40) on an exacto knife blade... touch the end of the blade to the shaft to be lubed... tilt the exacto knife handle up so the lube runs down to the tip and exactly where you want it... I lubed it and ran it a few seconds... then lubed again.... ran again.. three times.

Anyway I am sure you master builders out there know all these little tricks but this is for the newer people who may not know...
saabguyspg is offline Find More Posts by saabguyspg
Reply With Quote