Thread: Discussion New: Multiplex Acro Master
View Single Post
Old Jul 16, 2006, 05:37 PM
mudlark is offline
Find More Posts by mudlark
Happy Days
mudlark's Avatar
United Kingdom, High Wycombe
Joined Mar 2001
4,641 Posts
I stuck my halves together with uhu por. Works well plus flexable.

Got mine up for its' maiden, with my mate as well,,it was great. Had to move the CofG just forward of the 110mm and add 100% expo on every thing, now a lot tamer but it's there if you need it. The roll and spin rate are bonkers. Knife edge is great but keep the power up or it'll just sink.

Second flight was when I got the wot vibration, well just over half throttle actually. Figure it out at the time that I'd lost the cross peice (hadn't read the earlier post). My mate was suffering from the same problem with his.
We will be refixing a sturdier cross member soon. Well he will,, I on the other hand will be re-building the frount end after a very bad timing for the bec to cut, which resulted in no power and a steep inverted dive with no control responce. This is when you find the difference between an AM and a skycat. The frount end is not crash resistant AT ALL so I urge you all
DON'T LAND ON IT'S NOSE

Oh well out with the glue.
Dave
mudlark is offline Find More Posts by mudlark
Reply With Quote