Thread: Build Log Eurofighter
View Single Post
Old Jul 16, 2006, 04:22 PM
Blackrat is offline
Find More Posts by Blackrat
Registered Loon
Blackrat's Avatar
South Africa, WC, Knysna
Joined May 2006
1,359 Posts
I have done a quick build guide, but only realised how dark the pics where once i was finished oh well.

There are two files a .dwg and a .wmf, i unfortuanately dont have any programs to make it easier to print

http://homepages.nildram.co.uk/~ccoe...urofighter.wmf
http://homepages.nildram.co.uk/~ccoe...urofighter.dwg

right click and save these files

here we go with the guide

cut out all parts on the outline and on the dotted line (obviously not where the bottom support braces go) i have used 6mm depron.
on the main fuselage just below the cockpit are 2 dotted lines, this is for the thickness of the lipo that you will be using.



you will need

2 main fuselage sides
2 bottom support strips
1 tail piece
1 cockpit
1 front nose stabilizer
the wings with the flaperons cut out



tape the tops of the main fuse together and position on the wings, i use hot glue as i find it quick and easy




slide the nose stabilizer into place, you might need to lightly sand the fuse to get it to fit



flip the model over and glue the bottom sections in, pulling the sides out so that they sit flush with the nose piece

glue the bottom support strips in

if you can resist dont glue the tail fin on just yet, as it does get in the way when installing the radio gear , i couldnt



two covers to go, one over the nose so that the lipo can slide in, and the other to cover the 'innerds'

ill leave that for tomorrow
Blackrat is offline Find More Posts by Blackrat
Reply With Quote