Thread: Discussion Glostik Design and Build Thread
View Single Post
Old May 30, 2006, 07:22 PM
UAVPilot is offline
Find More Posts by UAVPilot
Foam Floats Better
UAVPilot's Avatar
The Big Country of TX.
Joined Oct 2004
2,977 Posts
Here is a tail design that I'm going to use on this model.

The second pic shows a possible choice one might make, to give it that older look.

The verticals on these models are full flying, meaning the whole thing moves. This lets you sandwich a LED between the two 2mm halves. You don't have to do it this way. You can make it out of flat 3mm depron, and just put a hinge line, but it won't light up the same way.

If you go full flying vertical, this is why you need a carbon rod that will fit inside the 1/8 carbon tube. The axle uses it also.
UAVPilot is offline Find More Posts by UAVPilot
Reply With Quote