Thread: Cool Let's see the S.P.A.Ds
View Single Post
Old May 16, 2006, 05:19 AM
Desert flier is offline
Find More Posts by Desert flier
Registered User
Desert flier's Avatar
Australia, SA, Morphett Vale
Joined Oct 2004
1,542 Posts
The spar had doublers glued to the front and back with a spacer glued on the front the carbon rods were used as pins to hold the front of the wing to the fuse. I only used woodwork CA glue and scrathed the varnish to roughen it up mark 2 will have the varnish completly removes and epoxy glue for the jint with fiberglass wraped around the joint. I am a beginer at power flying the most stress comes from landing ( ariving ) not from load in the air. The joint came apart in a previous spin in and I squirted glue into the jount and clamped it this probably was a waRNING sighn that i missed.
Desert flier is offline Find More Posts by Desert flier
Reply With Quote