View Single Post
Old May 04, 2006, 11:18 AM
Unconventional is offline
Find More Posts by Unconventional
Registered User
H.R. Colorado
Joined May 2006
13 Posts
Thanks. Most of the design was by trial and error since I don't have any modelling / design software. I have had a couple of flashes of insight that have made a big difference but mostly it goes like this:
step 1: think up something
step 2: build it
step 3: realize you made a critical thought error
step 4: rebuild it
step 5: test it / crash it
step 6: go back to step 1

By the way, how would you mount your relays? On the tilt shaft? And how would they bypass the signal around the gyros / devices?
Unconventional is offline Find More Posts by Unconventional
Reply With Quote