View Single Post
Old Apr 07, 2006, 05:23 PM
chara is offline
Find More Posts by chara
registered foam addict
chara's Avatar
Munich, Bavaria
Joined Dec 2004
1,265 Posts
OK I'm done with the linkage - looks promising and I'm confident that it will give much better roll rates.
here come some details of the 4-ailerons linkage. was very simple to do.
take a round CF rod and 4 short pieces of CF tube with matching inner diameter.
drill a hole for the axle into the tubes - test fit the assembly to the ailerons and then fix it with CA.
i use double sided carpet tape to stick the needle to the TE of the aileron and wrap around a strip of clear tape.

this video shows how it works and gives you also an idea of the control surface's throws that i use:

http://www.rcgroups.com/forums/showt...34#post5300328

good night everyone...
chara
chara is offline Find More Posts by chara
Reply With Quote