Thread: Question Puddle Twin XL
View Single Post
Old Mar 23, 2006, 08:09 PM
Figure9 is offline
Find More Posts by Figure9
Registered User
Figure9's Avatar
Granger,IN
Joined Oct 2001
150 Posts
No, I didn't take anymore pictures, but here are a few pointers:
Cut the top half of the wing a little wider because of the curve of the wing profile.

For the wing spar, I used a carbon arrow shaft imbedded in 3 layers of fff.

On the trailing edge, I sanded the last 1.5" to half thickness, so that when you fold the wing over, the trailing edge will not be so thick.

Before you glue the wing together, glue in some extra material where the wing floats get mounted.

Good Luck
Figure9 is offline Find More Posts by Figure9
Reply With Quote