Thread: Build Log Stevens Aero Edge 1.5
View Single Post
Old Feb 07, 2006, 07:06 AM
feathermerchant is offline
Find More Posts by feathermerchant
Use the 4S Luke
feathermerchant's Avatar
USA, TX, Euless
Joined Aug 2003
9,421 Posts
At 175 on my iron it will seal and slowly shrink SoLite. But in this application, it won't even tack until all the water is gone. If you set it much hotter, the water will start to vaporize and create steam bubbles. Very ugly. As it is, the heated water expands under the covering and you can see right where it is. Then you can still squeegee it out because the covering is not glued down yet.
feathermerchant is offline Find More Posts by feathermerchant
Reply With Quote