View Single Post
Old Jan 31, 2006, 04:47 AM
Eibo Morakinaga is offline
Find More Posts by Eibo Morakinaga
Master of the Skies
Seattle
Joined May 2005
200 Posts
also note the cutout in the tail for easy access to my main shaft linkage, this is the rear of the shaft, so I can check the "seat" to make sure everthings ok. I suspect I might have problems with the 5 degree angle in the gear. But I dry tested it and it was fine at 1400 rpms. very little chatter...that I think will also discipate with the foam that I shot into the Tail section, per my friends suggestion. Man, that really worked too!
Eibo Morakinaga is offline Find More Posts by Eibo Morakinaga
Reply With Quote