Thread: Discussion PCB etching problem
View Single Post
Old Jan 27, 2006, 04:04 PM
jonathan8388 is offline
Find More Posts by jonathan8388
Registered User
Elmwood Park,NJ, United States
Joined Nov 2004
970 Posts
so basically, i am leaving the board in the etchant too long, right? the minimum time that i could etch the board was 20 minutes, and that still meant pitted holes in the board. what do you recommend that i should do?

the toner MUST be the problem, becuase i got better results when using an ink marker. this means that the etching shouldnt be the problem.

how would i use the GREEN TRF? do i spray it on the image after printing? or do i spray it on the image afer ironing?
jonathan8388 is offline Find More Posts by jonathan8388
Last edited by jonathan8388; Jan 27, 2006 at 04:14 PM.
Reply With Quote